Gunnebo Speedstile Fl Installation Manual <Trusted Source>

Remove all tools, packing material, and personnel from the lane path. Turn on the mains power breaker.

What specific (RFID, face recognition, QR code) are you integrating?

: Manually rotate the glass panels before connecting power. Check for low oscillation; high movement without encoder motion can indicate mechanical issues. 3. Electrical & Logic Setup

Connect the factory-supplied synchronization harnesses between the Master and Slave columns. gunnebo speedstile fl installation manual

The installation typically involves securing the cabinets using anchor bolts, requiring a minimum bolting depth of 70mm into concrete. Installation Procedure Gunnebo SpeedStile FLS Installation Guide

Carefully uncrate the master (drive) cabinets, slave (receiver) cabinets, and center expansion cabinets (if deploying multi-lane configurations).

The Gunnebo SpeedStile FL is a reliable and efficient pedestrian gate solution for secure access control. By following this installation manual, you can ensure a successful installation and optimal performance of the SpeedStile FL. If you have any questions or concerns, please consult the Gunnebo support team or a qualified installation professional. Remove all tools, packing material, and personnel from

Standard SpeedStile FL models are designed for indoor use only. Temperature: Maintain an operating environment between 0∘C0 raised to the composed with power C +45∘Cpositive 45 raised to the composed with power C Humidity: Maximum 95% relative humidity, non-condensing. Electrical and Communication Conduits

Reposition the cabinets, insert the expansion anchors, and use a spirit level on the top chassis rail to verify vertical and horizontal plumbing. Insert steel shims under the baseplate if adjustments are needed.

features a new electronic platform, typically including an RS485 and COMR1 switching interface : Manually rotate the glass panels before connecting power

Ensure the turnstile mechanism is powered off and manually locked in the center position.

: The installation surface must be flat and level to within ±5plus or minus 5 mm over the entire footprint.