For the Fife CSP-01 to guide accurately, the connected sensors and actuators must be properly calibrated to the material being processed. Step 1: Sensor Calibration (Nulling) Clear all material out of the sensor detection gap. Navigate to the sensor calibration menu on the CSP-01. Record the "Unblocked" or "Dark" value.
Typically IP54 or face-mount equivalent for industrial environments
Locate the (or Offset) potentiometer on the face of the CSP-01. Fife Csp-01 Manual
: Typically an ultrasonic or infrared sensor that detects the web's position.
Adjust the Zero pot until the center-alignment LED lights up, indicating the controller recognizes the current web position as the desired baseline. For the Fife CSP-01 to guide accurately, the
Because the CDP-01 is a legacy product, many facilities now use to transition to modern systems like the D-MAXE series. These kits allow manufacturers to reuse existing Fife peripherals while benefiting from the increased processing power of newer controllers.
| Common Model | Description | | :--- | :--- | | CSP-01-06 | Standard guide control, often sold as a used unit | | CSP-01-13 | Edge guide controller with 125 VA power supply | | CSP-01-MVRC | Variant with ESU11 board and 140 VA power supply | | CSP-01-06RC | Web guide controller for lateral web positioning | | CSP-01-06 ESU-01 | Sensor guide controller for web alignment | Record the "Unblocked" or "Dark" value
Physically position the sensor so that the desired web edge sits exactly in the middle of the sensor's proportional band (the viewing window). Step 2: Sensor Calibration (Gain and Zeroing)
