It is recommended to perform a walk-test at least once a year to ensure the safety curtain correctly detects objects in the threshold prosecure opti combi
Standard wiring for the Prosecure Opti Combi typically follows this color-coded configuration: : Power supply (Ground). Brown (+) : Power supply ( Green (-) : Microwave module output (Activation zone). Yellow (+) : Microwave module output. Grey (-) : Test input. Pink (+) : Test input. Blue (-) : Infrared module output (Safety zone). Red (+) : Infrared module output. LED Status Indicators The sensor's LED provides immediate feedback on its status: Solid Green : Device is ready for operation. Solid Red : Detection is active (motion or presence). Flashing Green : A remote command has been received. Flashing Red : A fault has been detected. Flashing Red/Green : Initializing after power-on. Configuration & Adjustments
The sensor is generally rated for temperatures between -15∘Cnegative 15 raised to the composed with power C +50∘Cpositive 50 raised to the composed with power C
Drill the specified pilot holes for the mounting screws and the cable entry hole. prosecure opti combi manual english
Angle the radar module outward away from the door, or lower the radar sensitivity dial slightly. The door stays open and the LED is permanently solid orange
The floor baseline changed, or the IR curtain is hitting an object, or the safety output logic is inverted.
Adjust the side-shrouds or use electronic DIP switches to turn off the outer safety spots if the door frame is narrow. 5. Programming via DIP Switches and Buttons It is recommended to perform a walk-test at
This article provides a comprehensive overview of the , covering installation, technical specifications, programming, and troubleshooting based on standard operational protocols. 1. Introduction to ProSecure Opti Combi ProSecure Opti Combi Go to product viewer dialog for this item.
Typically 2.0m to 4.0m (Standard setting is often 2.5m to 3.5m) Detection Speed Minimum 5 cm/s Made-in-China.com Supply Voltage 12V to 24V AC/DC Made-in-China.com Transmitter Frequency 24.150 GHz (Microwave) Made-in-China.com Protection Class Typically IP 54 (suitable for dust and splash protection) Installation & Configuration Essentials
: Insert a flathead screwdriver into the designated slots at the rear or bottom of the casing. Gently twist and lift the cover upward to expose the internal modules. Do not pull from the top. Grey (-) : Test input
Before operating the Opti Combi, observe these critical safety rules:
by removing the batteries or power supply and then returning power. Note: Power must be removed for at least 10 seconds to ensure a proper reboot.” Scribd
Most Prosecure Opti Combi models feature a digital display or a series of DIP switches and potentiometers to fine-tune performance. Radar (Motion) Adjustments