Turn the fan on high speed. If it wobbles, use the included balancing clip by sliding it onto the back of any blade. Move it until the wobble stops, then affix a balancing weight at that location.
Secure the tiny safety screw and nut located at the very bottom of the guard rim. Operating Instructions Control Panel & Remote Functions
: Some portable or indoor "Sunrise" branded fans (like those from Sunrise Tradex) include remotes with Timer , Speed (HI, ME, LO), and Mode (Normal, Nature, Sleep) functions. Wiring & Safety
Carefully unpack your box and verify that all the following components are present: Weighted bottom piece for stabilization. Extension Pole: Adjustable column (for pedestal models). sunrise fan manual
Disclaimer: This article serves as a comprehensive guide for general Sunrise brand ceiling fans. For specific models, always refer to the manual included in your product packaging.
Two fans in one room operating together? Change one fan’s dip switch to a new unique combination (e.g., 1-Up, 2-Down, 3-Up, 4-Down). Re-program remote to match.
Always unplug the electrical cord before initiating any cleaning process. Turn the fan on high speed
: Cut a 14.5-inch diameter hole between rafters, roughly 24–30 inches down from the roof peak. Mounting (Flat Base) :
The Sunrise Fan manual defies the typical trifold chaos of multilingual safety warnings. Instead, it opens like a short story.
The Ultimate Sunrise Fan Manual: Installation, Usage, and Maintenance Secure the tiny safety screw and nut located
Read all safety guidelines before installing or using your fan.
Check your home electrical panel and reset the breaker switch. Blown safety fuse in plug. Replace the fuse in the plug with an identical amp rating. Excessive dust accumulation. Clean the front guard, rear guard, and internal fan blades. Obstruction near rear grille. Move the fan away from walls, curtains, or loose fabrics. Abnormal noise/vibration Loose fan blade or grille.
Insert the lower end of the extension pole into the center hole of the base.
Tighten the two set screws on the motor collar to lock the downrod in place. Step 3: Hang the Fan Lift the fan assembly up to the mounting bracket. Seat the hanger ball into the mounting bracket socket.