Ge Timer Switch 532641l3 Instruction Manual Pdf Pdf Install ~upd~ -
: Tuck wires carefully into the box, mount the timer with provided screws, and restore power. It may take about 1 minute to fully charge before it functions. Programming Guide
Strip the building's solid or stranded copper lines to expose roughly 3/8 inch to 5/8 inch of raw metal. Step-by-Step Single-Pole Wiring Diagram
Check the AM/PM settings on both the current clock time and the program blocks.
Connect the ground wire from the timer to the Bare/Green ground wire in the wall box.
: Remove the existing wall switch and strip the building wires to approximately 3/8 inch. Identify Connections Black Wire : Connect to the Line (Hot) wire from the power source. : Connect to the wire (the wire going to the light/appliance). White Wire : Connect to the ge timer switch 532641l3 instruction manual pdf pdf install
Press and hold the or Set button until the time display begins to flash.
Your keyword search— — suggests you want a direct, printable document. Here are three reliable ways to get it:
, follow these steps meticulously, as found in the SunSmart Digital Timer Instructions. Preparation
| Parameter | Rating | |-----------|--------| | Voltage | 120–277 VAC, 60 Hz | | Resistive load | 40 A (240 VAC) | | Tungsten / Ballast | 10 A @ 120 VAC | | Motor (HP) | 2 HP @ 120/240 VAC | | Timer mechanism | Synchronous motor (24-hour dial) | | Minimum ON/OFF time | 30 minutes (using two trippers) | : Tuck wires carefully into the box, mount
: Test the sensor at dusk to confirm it activates properly as light levels drop. JustAnswer Troubleshooting Lights Stay On/Off
Once the timer is physically installed, the next step is to program it.
Use the and Min buttons to select your desired start time.
Check that the Neutral wire is properly connected. Identify Connections Black Wire : Connect to the
Electrical work is dangerous. This guide supplements the official manufacturer manual. When in doubt, hire a licensed electrician. The author assumes no liability for incorrect installation, fire, shock, or equipment damage.
: Typically a white wire, often found bundled in the back of the box. : Usually a bare copper or green wire. Connect the Timer Connect the Black (Line) lead to the hot power wire. Connect the Red (Load) lead to the load wire. Connect the White (Neutral) wire to the neutral bundle in the box using a wire nut. Connect the Green (Ground) lead to the ground wire.
The following steps are condensed from the original manual.